Topics created by Deluxe 600

@kb58 said in Filament sensor:

I have a very similar situation. I'm about to add a filament sensor and have two questions:

The question above that was already asked, must the detector be connected to the same (tool) board that's running the extruder?

If I'm using a tool board, in the M591 configuration, Is the correct parameter "D121.0" since the extruder is run from the tool board, or just "E0"?

I know, the thread is a little bit old. But I had the same questions, nobody has been answered and maybe it will help other users with Filament sensor and 1LC...

Yes, it have to... D0 is ok. Here's my config. ; Filament sensor (Duet) M591 D0 P3 C"121.io1.in" S1 R70:130 L24.8 E3.0 ; Duet3D rotating magnet sensor for extruder drive 0 is connected to E0 endstop input, enabled, sensitivity 24.8mm.rev, 70% to 130% tolerance, 3mm detection length M591 D0 ; display filament sensor parameters for extruder drive 0

Sending M591 by itself will report info on the sensor.

@Deluxe-600 said in Pause.g Resume.g problems:

@fcwilt Yes the very first line in the file.

That seems very odd.

Thanks.

Frederick

Ok, i will manage. Thank you.

Ooooh. I knew it had to be something simple 🙂 . Thank you very much kind sir, have a great day.

@droftarts Oh yeah found it! I cant believe i havent noticed 🤔 . Anyway thank you for your help in understanding the problem. It works much better now . Have a great day 🙂

@Phaedrux I managed to solve all the problems by updateing the software and lowering the current a bit. Thank you for the help.