Topics created by Aurimas

@Aurimas That's pretty ingenious.
Though personally I wouldn't care about anyone's patent, so long as I'm not selling the equipment, or building and providing that equipment to potential customers of the patent.

Maybe I'm in the wrong with my thoughts, but to me most of this is a hobby and not stealing their profits.

@droftarts Thanks Ian

@dc42 just as suspected 🙂
filament counter is counting correctly anyway.

@dc42 just yesterday I had that issue, changed the Z minimum to allow negative value and it was printing since.
although it would be difficult to test your suggestion since the error didn't happen 100% of the time or in the same spot.
so my theory would be that if there is some inconsistency in the measurements at different spots of the bed it wants to compensate below minim and that is when it has fits.
It is always in the random spots on the bed (mostly well within limits) and not always - only sometimes.

@Aurimas no. You need that file on the SD card and the only way to get it there is to pull the SD card and do it manually

@o_lampe said in AuruMMS - multi colour/material unit running on Duet:

Hope to see more of your machine in the future.

Reply

The cutter is independent - on the extruder in this case similar to Bambu/Voron setups.
Also have designed actuator activated cutter that can sit just above the extruder 🙂

@oliof said in weird issue with fans:

Main difference between your IDEX and mine is that you have a chamber fan and an electronics fan(? seems to be disabled in the config); so it's not a perfect match but the best I can do.

thank you for trying

@Aurimas next time this happens, please run M122 B# where # is the CAN address of tool board, and post the output here.

@Aurimas said in Filament error on extruder 0: sensorError:

why would it run sometimes for hours and hours on the same printer and then throw an error every 15min?

🤷 If I knew that, I'd just tell you what to fix!

Ian

Has this happened again since?

@gloomyandy thanks.
I waas hoping for a little better option, but if it is all that can be done this will have to do it 🙂

@Aurimas Yours was the only BLtouch related posting I saw on RC3 . Mine seems to probe OK, I tried it twice and a G32 just in case and they work fine. . Had that error at first and went looking to see if something changed in the config.

@T3P3Tony said in issue with 1LC+3.5.0RC2 and magnetic filament sensor V3:

When you say you are powering up and down to change the filament monitors, is that just the toolboard or the whole system?

the whole system
yes - no changes in the loom or anything else

@OwenD great - thank you

I am also having a similar issue. I am on 3.5.0 b4. Uploading files is hit or miss. DWC will disconnect and refresh. If I keep retrying it will eventually work. The larger the file, the more I need to retry. It was fine when I was on 3.4.5. I upgraded firmware to address other issues.

Running 3.5.0 rc2 causes layer shifts when using input shaping so upgrading is not an option

@dc42 thank you

@droftarts it doesn't really matter what mode it is

@dc42 said in Duet mini keeps restarting if the toolboard is missing:

@Aurimas thanks for confirming. The problem occurred when a filament monitor was configured on a missing expansion board.

as long as it is not me it is all good 🙂
thanks again