duex5 setup

Phaedrux

RepRapFirmware for Duet 2 WiFi/Ethernet version 3.4.5 (2022-11-30 19:36:12) running on Duet Ethernet 1.02 or later + DueX2v0.11

Well it's not a firmware issue, but there may be something wrong with your Duex causing it to report as a Duex 2.

Can you please try reseating the ribbon cable to the Duex?

When and where did you purchase the Duex?

dc42

@rister502dad current production (version 0.11) DueX5 boards have a jumper that put them into DueX2 mode. It's at the top left corner of the witing diagram at https://docs.duet3d.com/Duet3D_hardware/Duet_2_family/DueX2_and_DueX5#wiring-diagram. So if your DueX is version 0.11, make sure that jumper is fitted. There's another diagram showing it at https://docs.duet3d.com/en/Duet3D_hardware/Duet_2_family/DueX2_and_DueX5#duex5-v011-with-external-drivers.

rister502dad

@dc42 Thanks for the suggestion I removed the jumper and tried again to install the firmware but it didn't work as well.

rister502dad

@rister502dad
Hi Phaedrux
I got this board from Filastruder on May 15th order 92688

This board has actually never worked for me, the heaters work but not the steppers. I have had issues with the heaters in the past too and have wondered if there is something up with this board but then again there is a lot to understand about how the Duet works and those issues were resolved by messing around with the config file.

Phaedrux

@rister502dad said in duex5 setup:

@dc42 Thanks for the suggestion I removed the jumper and tried again to install the firmware but it didn't work as well.

So the jumper was already present before? It should be installed to show as a Duex5, not removed.

rister502dad

@Phaedrux I didn't know about this jumper until today when I was advised to remove it. Either way I still am stuck having tried both ways.

dc42

@rister502dad I didn't advise you to remove the jumper, I advised you to check that it was fitted.

Phaedrux

@rister502dad said in duex5 setup:

Either way I still am stuck having tried both ways.

Understood. Please send an email to warranty@duet3d.com and CC your reseller. Include a link to this forum thread and the details of your original purchase. You'll receive a reply with a form to fill out.

rister502dad

@rister502dad ok sorry for the misunderstanding does seem to make sense to not mess with it to begin with

rister502dad

@rister502dad Cool thanks for the support.