All Drivers give me disconnected reported by driver

Phaedrux

Chances are the error message is telling you exactly what's wrong. The motor phases are incorrect.

First you should identify the motor phase pairs and wire them accordingly.

If you've identified the pairs and are sure you have them wired correctly you can do further troubleshooting.

DruckKlaus

Ofc i did. As said i first did it like it is supposed to be. It didnt work. And then i tried like everything else possible.

Phaedrux

Does it still report the error on all drivers with only 1 motor connected?

DruckKlaus

Short answer is: it reports it anytime. Dont matter if something is connected or not.

Phaedrux

Did it work correctly for your friend before they gave it to you?

DruckKlaus

atleast he said i did. he is trustworthy. thats the only reason i try to get it to run and not discard it already.

Phaedrux

What are the specs of the motors you're trying to use?

DruckKlaus

What are the specs of the motors you're trying to use?

Veti

M906 X1400 Y1400 Z1400

you are running 0.8A motors with 1.4A.

DruckKlaus

@Veti theyx running fine on this current. on the back, they got written 2.4A. Before i run them also with 1.4 and all was fine. they are pretty beefy

Veti

then you posted the wrong spec sheet.

do you have a motor of different make that you can test?

DruckKlaus

then you posted the wrong spec sheet.

do you have a motor of different make that you can test?

y tested and the same issue

DruckKlaus

Veti

can you measure the resistance between the red and blue wire and between the green and black wire?

DruckKlaus

1.3ohm between each

Veti

can you post a picture of the motor connection on the duet?

DruckKlaus

ofc, i dont lnow why but ofc

DruckKlaus

DruckKlaus

@T3P3Tony u may got any idea ?

dc42

Try removing the D2 from the M569 commands in config.g.