All Drivers give me disconnected reported by driver

Phaedrux

Does it still report the error on all drivers with only 1 motor connected?

DruckKlaus

Short answer is: it reports it anytime. Dont matter if something is connected or not.

Phaedrux

Did it work correctly for your friend before they gave it to you?

DruckKlaus

atleast he said i did. he is trustworthy. thats the only reason i try to get it to run and not discard it already.

Phaedrux

What are the specs of the motors you're trying to use?

DruckKlaus

What are the specs of the motors you're trying to use?

Veti

M906 X1400 Y1400 Z1400

you are running 0.8A motors with 1.4A.

DruckKlaus

@Veti theyx running fine on this current. on the back, they got written 2.4A. Before i run them also with 1.4 and all was fine. they are pretty beefy

Veti

then you posted the wrong spec sheet.

do you have a motor of different make that you can test?

DruckKlaus

then you posted the wrong spec sheet.

do you have a motor of different make that you can test?

y tested and the same issue

DruckKlaus

Veti

can you measure the resistance between the red and blue wire and between the green and black wire?

DruckKlaus

1.3ohm between each

Veti

can you post a picture of the motor connection on the duet?

DruckKlaus

ofc, i dont lnow why but ofc

DruckKlaus

DruckKlaus

@T3P3Tony u may got any idea ?

dc42

Try removing the D2 from the M569 commands in config.g.

DruckKlaus

Try removing the D2 from the M569 commands in config.g.

Wont change anything. Started without and just added it as a hope it would help.

Danal

Does the white connector and the black connector go to the same model of motor?

If so, one of them has to be wrong.

Those cannot both be true (if the cables are consistent on the other end, and plug into the same model motor).

Please show a photo of where the white cable plugs into the motor and similar photo for the black one.