Panel Due stopped working

Phaedrux

Have you updated the IAP files? Update those are try the firmware again.

brian

@phaedrux No, ok found those, i assume they go in /sys folder?

brian

Copied IAP4E.bin to sys folder.

No change.

Deleted DuetwifiFirmware file from /sys folder

copied Duet2CombinedFirmware.bin to /sys folder and ran M997 S1 command and it reported Success

ran M115 to check and it reports same as before 1.19beta 7

Phaedrux

I think there are 3 IAP files.

You could also try upgrading to the full version of 1.19 first in case it's an issue with upgrading from a beta firmware.

brian

@phaedrux Ok thanks, i will do that.

Installed v1.19+6. The version update does update to this version.

No change as far as the panel duo working right, tho.

When i run the macro "setNetwork" it returns;

Macro file: "0:/macros/setNetwork" not found. also same as before

dc42

@brian said in Panel Due stopped working:

Copied IAP4E.bin to sys folder.

No change.

Deleted DuetwifiFirmware file from /sys folder

copied Duet2CombinedFirmware.bin to /sys folder and ran M997 S1 command and it reported Success

ran M115 to check and it reports same as before 1.19beta 7

Rename your downloaded Duet2CombinedFirmware.bin file to DuetWiFiFirmware.bin, upload it, and accept the invitation to install it.

Pat

@dc42
After a lot of trying i finally had the idea to flash it with my tablet and its working again.
I dont know whats the problem with my pc.
Tested different cables, usb-ports and versions of bossa.

dc42

@pat said in Panel Due stopped working:

@dc42
After a lot of trying i finally had the idea to flash it with my tablet and its working again.
I dont know whats the problem with my pc.
Tested different cables, usb-ports and versions of bossa.

I'm glad you got it working again. I don't understand what caused the problem, because Bossa from a PC should work as long as you:

Download the correct firmware file correctly, and select it in Bossa.
Check the Erase All, Lock, and Boot To Flash buttons before pressing Write.
After the Write finishes, press Verify. I have known Bossa to say that the write is complete, but for the Verify to fail.

brian

@dc42 Thank you, it now updated to v2.0(RTOS) and i have full function on the panel due ftf.

However still cannot connect to network.

dc42

@brian said in Panel Due stopped working:

@dc42 Thank you, it now updated to v2.0(RTOS) and i have full function on the panel due ftf.

However still cannot connect to network.

I suggest you run M122 to check that you have DuetWiFiServer 1.21 installed.

brian

@dc42 M122 reports;
WifFi/Ethernet version 2.0(RTOS) running on Duet WiFi 1.02 or later Board ID: ....a very long sequence of letters.

Nothing else.

dc42

The wifi firmware version is given in the Network section of the M122 report, unless the WiFi is still in the Disabled state.