Panel Due firmware 1.20 released
-
I have a CPLD and dimming settings do not do anything, screen never dims.
-
I was looking in the wiki for the update instructions and they don't appear to be there.
Is this the only place they exist?
-
hi,
after updating Panel Due to version 1.20(15b1)…. dont conect with Duet... at power on Panel Due show the message conecting in upper right of screen...
I have checked wiring continuity, and is correct.
The screen power on, but dont show info of Duet... Before the update works well...I can downgrade? where i can find an older version.... and what version is confirmed to work?
i have: Panel Due 3 + 5" Screen.
I have instaled this firmware: https://github.com/dc42/PanelDueFirmware/releases/download/1.20/PanelDue-v3-5.0.bin
-
I was looking in the wiki for the update instructions and they don't appear to be there.
Is this the only place they exist?
Yes.
-
hi,
after updating Panel Due to version 1.20(15b1)…. dont conect with Duet... at power on Panel Due show the message conecting in upper right of screen...
I have checked wiring continuity, and is correct.
The screen power on, but dont show info of Duet... Before the update works well...I can downgrade? where i can find an older version.... and what version is confirmed to work?
i have: Panel Due 3 + 5" Screen.
I have instaled this firmware: https://github.com/dc42/PanelDueFirmware/releases/download/1.20/PanelDue-v3-5.0.bin
I can't see any reason why it won't connect. Did you remember to reconnect the cable between PanelDue and your Duet after upgrading the firmware? Perhaps there is a bad crimp connection in the cable, and disconnecting/reconnecting the cable disturbed it.
-
I've noticed a few times that the 4 macro slots on the main screen will sometimes display the wrong macros if you have gone to the macro screen and entered a subfolder. When you go back to the main screen without going back up a level to the main macro folder it will try and show the first 4 macros from the subfolder rather than the main folder. This leads to the macro names being cut off and displaying incorrectly, and if you try and launch a macro you get an error saying the macro doesn't exist, because it isn't in the subfolder.
I hope that makes sense.
-
Thanks for reporting that, I'll fix it in the next release.
-
DC42 – ping, is dimming supposed to work in the C version? because for me it does nothing.
-
I don't think the C version supports dimming via the LED_A pin the way the other displays do. It might support dimming via the controller chip, but I would need the details to be able to program it.
-
This post is deleted!
