All Drivers give me disconnected reported by driver

DruckKlaus

@Phaedrux said in All Drivers give me disconnected reported by driver:

What are the specs of the motors you're trying to use?

https://cdn-reichelt.de/documents/datenblatt/X200/17HM5424DATASHEET.pdf

Veti

M906 X1400 Y1400 Z1400

you are running 0.8A motors with 1.4A.

DruckKlaus

@Veti theyx running fine on this current. on the back, they got written 2.4A. Before i run them also with 1.4 and all was fine. they are pretty beefy

Veti

then you posted the wrong spec sheet.

do you have a motor of different make that you can test?

DruckKlaus

@Veti said in All Drivers give me disconnected reported by driver:

then you posted the wrong spec sheet.

do you have a motor of different make that you can test?

y tested and the same issue

DruckKlaus

Veti

can you measure the resistance between the red and blue wire and between the green and black wire?

DruckKlaus

1.3ohm between each

Veti

can you post a picture of the motor connection on the duet?

DruckKlaus

ofc, i dont lnow why but ofc

DruckKlaus

DruckKlaus

@T3P3Tony u may got any idea ?

dc42

Try removing the D2 from the M569 commands in config.g.

DruckKlaus

@dc42 said in All Drivers give me disconnected reported by driver:

Try removing the D2 from the M569 commands in config.g.

Wont change anything. Started without and just added it as a hope it would help.

Danal

Does the white connector and the black connector go to the same model of motor?

If so, one of them has to be wrong.

The white connector is wired as though Red-Green and Blue-Black are coils.
The black connector is wired as though Red-Blue and Green-Black are coils.

Those cannot both be true (if the cables are consistent on the other end, and plug into the same model motor).

Please show a photo of where the white cable plugs into the motor and similar photo for the black one.

DruckKlaus

@Danal said in All Drivers give me disconnected reported by driver:

Does the white connector and the black connector go to the same model of motor?

If so, one of them has to be wrong.

The white connector is wired as though Red-Green and Blue-Black are coils.

The black connector is wired as though Red-Blue and Green-Black are coils.

Those cannot both be true (if the cables are consistent on the other end, and plug into the same model motor).
Please show a photo of where the white cable plugs into the motor and similar photo for the black one.

There is no connector on the motor.

DruckKlaus

This is my test Setup now because i need my printer working.
Using generic 200steps/rev motors.

Deneteus

@Danal Those steppers come pre-wired. They don't plug in with JST on the motor side.

oliof

It looks like the jumpers bridging the second (parallel) z stepper connector are missing.

DruckKlaus

@oliof said in All Drivers give me disconnected reported by driver:

It looks like the jumpers bridging the second (parallel) z stepper connector are missing.

iam using 2 z steppers. but neither of them is connected because of the problems i have ..atm just x and y are conncted.