How do I get these messages away every 5sec

Phaedrux

Your slicer appears to be inserting time remaining messages using M117.

Elko

No there is no M117 in the entire Gcode ??

Phaedrux

how bout the messages themselves. What slicer are you using? Can you share the gcode file?

Elko

I used S3DInduktiv_Z_Abstand2.gcode

Phaedrux

Perhaps this is a new feature in 3.1.0. I haven't tested it myself yet.

I can't read german so I'm not sure if there's an option there.

dc42

Most likely your slicer has inserted M117 commands in the GCode file that it generated. This is an option in some slicers.

Phaedrux

@dc42 Not in the case of the gcode he uploaded.

Elko

@dc42
no it is not an M117 in the entire Gode

Elko

chrishamm

@Elko Do you have a daemon.g in your system directory? The only reason those messages can pop up is from a M117 code somewhere in your config.

Elko

No, it is not an M117 M118 in the entire Gode or in a system / file

dc42

Are you running a Duet 3 with attached single board computer? If that's the case, are you using a DSF plugin that could be generating the messages?
Do you have anything connected to the USB port of the Duet?

Elko

I now know where the "error" comes from
I connected Repetier to the Duet2 via WLAN
This will probably poll the data for 5 seconds when I start printing from there
Only for INFO I am fully satisfied with the DUET2 super thing

dc42

@Elko said in How do I get these messages away every 5sec:

I now know where the "error" comes from
I connected Repetier to the Duet2 via WLAN
This will probably poll the data for 5 seconds when I start printing from there
Only for INFO I am fully satisfied with the DUET2 super thing

Looks like Repetier is sending those M117 command then! There may be an option in Repetier configuration not to generate them.

Elko

Thank you for your help
is not your problem !!
such a good support THANKS