Thank you for your help.
The limit switch was in the wrong PIN
Excuse me

Hi there,
when searching for "Gcode to turn off a tool?"
I came across this post
https://forum.duet3d.com/topic/3608/gcode-to-turn-off-a-tool?_=1635146253318
Is there now a GCODE command to switch off a tool?

Yes exactly like that

Hello
Is there any way to set an output when the Z stepper motor is no longer energized
RRF3 Duet2 WLAN

I don't have to change the chamber temperature frequently.
But with PLA I need a different chamber temperature than with ABS.
It would be nice to specify the temperature like a "hot end" temperature in the panel or DWC.

OK thanks
Too bad that there is no such possibility
then I will create macros with the different temperatures

Hi,
Yes, I also have the problem.
Got this code

M950 F6 C"duex.fan6" Q250                        
M106 P6 T40:50 H3 C"FAN6_Chamber" 

in config.g
The fan also controls the temperature, but I can only specify the temperature in code and not in DWC
Is there a way to enter this in the panel or in the DWC?

Ok, I understand it now
0X 0Y 0U are now in the middle of the bed
IT WORKS OUT

ok i have to look at this again i don't understand it at the moment
THANK YOU

There is no solution ?

@dc42
Hello the files here
I probably don't understand something right

M115
FIRMWARE_NAME: RepRapFirmware for Duet 2 WiFi/Ethernet FIRMWARE_VERSION: 3.1.1 ELECTRONICS: Duet WiFi 1.02 or later + DueX5 FIRMWARE_DATE: 2020-05-19b2

homez.g homey.g homex.g homeu.g homeall.g config.g