Topics created by Touchthebitum

@dc42 thanks

@siam said in Duet3 SBC no router:

If he configures the raspberry pi as an access point it should work

Thanks, hope it will work 😉

@fcwilt
Thanks, I'll check that

@Phaedrux Ok, I'll do that

@dc42 said in Mesh stops after end RRF3.2 beta 3:

@Touchthebitum said in Mesh stops after end RRF3.2 beta 3:

Confirmed and tested, mesh compensation works on 3.2 beta 2 but not on beta 3

Is this in standalone mode, or with attached SBC?

attached SBC (Rasp Pi4)

@Phaedrux said in 3.2 beta 2 and 3 strange behaviour during movements:

Thanks. I've moved to beta firmware forum for @chrishamm to see.

@Phaedrux said in 3.2 beta 2 and 3 strange behaviour during movements:

Thanks. I've moved to beta firmware forum for @chrishamm to see.

Thanks

@Touchthebitum
I decided to switch to Cura and it's awesome. I don't have problems anymore.
Problem solved 😉

@chrishamm
ok, I'll do that and hope that doesn't happen again 😉

@chrishamm Thanks

I found the problem. It was a loosen screw on one of the x/y motors.
Thanks for your help.

Thanks for the info

This thread is very confusing to follow because there are 2 people with problems posting in the same thread.

Best way to get accurate and timely help on a problem is to post a good description of the problem and include all of your config files. RRF is configured with gcode, so showing what gcode you are using is critical to helping others understand what's actually happening with the printer.

@Touchthebitum @sko if you want some more help getting your z offset correct, start new threads and include your files. It's usually a fairly simple fix to methodology.

@fcwilt
I found the problem. There was a piece in the hotend. Now I'm struggling against the z offset withe the bl-touch
Thanks all for your help

@zapta That is super clear. Thanks!
Thank you all.

@droftarts

Thanks for the info 😉

@Touchthebitum please email me info@duet3d.com and I will arrange a return directly