I found the problem. It was a loosen screw on one of the x/y motors.
Thanks for your help.

@fcwilt
The solution was M226 instead of M600.
I had to edit and place M226 at the right layer.
I kepts my pause and resume files and it worked.
Thanks for your help

I use 0.8 nozzle size too for large prints. I have this problem too but it seems that acceleration may be modified. Be careful with speed because extruder motor has to provide more speed for the print. So try to lower your print speed

@dc42
Not yet, do you mean adding gcode : G4 P50 ?

@dc42 thanks

@dc42 console.txt

@dc42 No, my homing process doesn't run G32.

@dc42 No, the problem stands when I run a print. Home is ok and then it freezes. PanelDue indicates printing.... I tried your update but it doesn't work.

Hello
After 3.5b1 update, it hangs after home process and print doesn't start...
How to downgrade please ?
Thanks

I use 0.8 nozzle size too for large prints. I have this problem too but it seems that acceleration may be modified. Be careful with speed because extruder motor has to provide more speed for the print. So try to lower your print speed

@jay_s_uk thanks

Hello
I'm trying to enable Plugin on the new 3.3.0 firmware.
sudo apt install apparmor worked
echo " lsm=apparmor" >> /boot/cmdline.txt give me an error message : -bash: /boot/cmdline.txt: permission denied

I can still activate plugin in DSW

Help please

@siam said in Duet3 SBC no router:

If he configures the raspberry pi as an access point it should work

Thanks, hope it will work

Hello
My friend doesn't have a router in his working place and would like to connect wirelessly to the Duet3 SBC with his laptop. Is it possible ?
Thanks