Mesh stops after end RRF3.2 beta 3

[Touchthebitum]

I'm trying to execute mesh compensation procedure but it hangs before the end and the system remains "busy". It was ok before upgrading.
Help
config.g
bed.g

Board: Duet 3 MB6HC (MB6HC)
DSF Version: 3.2.0-beta3
Firmware: RepRapFirmware for Duet 3 MB6HC 3.2-beta3 (2020-11-07)

[Touchthebitum]

Confirmed and tested, mesh compensation works on 3.2 beta 2 but not on beta 3

[oozeBot]

This appears to be the same thing I reported yesterday and debugged this morning..

https://forum.duet3d.com/topic/19633/duet-3-rpi-toolboard-on-3-2b3-g29-fails

[Touchthebitum]

@oozeBot said in Mesh stops after end RRF3.2 beta 3:

This appears to be the same thing I reported yesterday and debugged this morning..

https://forum.duet3d.com/topic/19633/duet-3-rpi-toolboard-on-3-2b3-g29-fails

Thanks, I didn't see it.
Let's stay tuned

[dc42]

@Touchthebitum said in Mesh stops after end RRF3.2 beta 3:

Confirmed and tested, mesh compensation works on 3.2 beta 2 but not on beta 3

Is this in standalone mode, or with attached SBC?

[Touchthebitum]

@dc42 said in Mesh stops after end RRF3.2 beta 3:

@Touchthebitum said in Mesh stops after end RRF3.2 beta 3:

Confirmed and tested, mesh compensation works on 3.2 beta 2 but not on beta 3

Is this in standalone mode, or with attached SBC?

attached SBC (Rasp Pi4)