Topics created by synergy41

Remove the G29 S1 from the end of your config.g file. You don't want to load the mesh at startup, only before a print. Better to add it to your slicer start gcode after G28 to home and G32 to calibrate.

Also after the delta calibration you may want to do another single G30 at the center of the bed to reset Z0.

I think the problem was that your old config didn't have an M584 command and there were defaults in older firmware. There a no longer defaults and the M584 command must be present.

it works again now. I just deleted M550 and reinstalled it. Thanks for all you do.

@dc42 said in Bed is working more since the update:

Please read the upgrade notes for RC10.

Thank you my friend, you are great. I had not read this.
Solved now

The huge drop shown in the temp graph indicates that the sensor has lost communication with the board entirely. Failing crimp or cable exacerbated by movement and flexing during a print as you've found.

@DIY-O-Sphere
thank you

Thanks to you 2, that was it.

What do you mean by reset or upgrade?

If you mean upgrading to latest stable firmware, see https://duet3d.dozuki.com/Wiki/Installing_and_Updating_Firmware.

If you mean resetting the files on the SD card, it's generally easiest to use the online configurator at https://configurator.reprapfirmware.org/Start.

Put the following at the end of your bed.g:

G91
G1 Z-5
G90
G1 X0 Y0

and check the result.

@dc42 Thanks for the answer David,
unfortunately I am limited by the speed of withdrawal of my extruder "ED3" this one mache filament when I put a speed too high.
On the other hand I try to print a cube in vase mode and I have no problem, I must find the difference in my setting in my profile Simplify 3D.

That's the wrong folder. Those files and folders must be in folder /www. I think you have some old DWC files in /www instead.

@synergy41 also in the DWC manual here: https://duet3d.dozuki.com/Wiki/Duet_Web_Control_Manual#Section_General