G32 does not work " RESOLVED "
-
Hello everyone,
I was forced to reinstall my duet wifi on my delta little monster because it did not want to make a home in Z0 and Y0.
Now everything is in order except that I have a problem when I run a G32.
My delta feels all the points as expected but it does not show me any results when I enter orders M665 and M666.
So I think the calibration is not done properly.
I enclose a screenshot and the files on my card,
thank you
0_1552840100182_config-override.g
-
no one has an idea of the problem?
-
As far as I can tell you your bed.g is missing a G30 command with the appropriate S-Parameter to perform the desired calibration calculation.
See https://duet3d.dozuki.com/Wiki/Gcode#Section_G30_Single_Z_Probe and https://duet3d.dozuki.com/Wiki/Setting_up_automatic_probing_of_the_print_bed.Also, you may need to include a M501 command a the end of your config.g to enable execution of config-override.g.
-
Okay, I'm looking tonight when I get home from work.
-
@themelle said in G32 does not work:
As far as I can tell you your bed.g is missing a G30 command with the appropriate S-Parameter to perform the desired calibration calculation.
See https://duet3d.dozuki.com/Wiki/Gcode#Section_G30_Single_Z_Probe and https://duet3d.dozuki.com/Wiki/Setting_up_automatic_probing_of_the_print_bed.Exactly that. The last G30 command in bed.g needs the S parameter, normally S6 or S8 to calibrate a delta.
-
Thanks to you 2, that was it.