Hotend does not stop anymore since update 1.19 + 3
-
Hello everyone,
Since I made the update in 1.19 + 3, my hotend stays on at the end of a print, whereas before this update my hotend switches to 0 ° by itself at the end of its printing cycle .
I have absolutely nothing to change in the end script.
I put my script on you if you see anything.- "G28 ; Home all axes
M140 S0 ; Set Bed Temperature
M84 ; Stop idle hold
G1 E-3 ; Remove 3.00mm of material
M104 S0 ; Set Extruder Temperature
M106 S0 P0 ; Stop Fans Print"
Thank you for all the work produced around this card which is truly amazing.
- "G28 ; Home all axes
-
Thanks for your report. As a temporary workaround, if you put a M400 command before the M104 command then it should work.
-
Thanks David
That was the solution it works.
thank you
Good work