Topics created by micaheli

@Forum-user It's basically backwards. It would be far more effective to have the high static pressure output blowing across the drivers.

@droftarts Great! Thanks for the link. That help a ton. I haven't ruined mine yet, but I'm more than prepared to accept that I might. Failure is always an option.

@droftarts I do have crimpers. I used to do a lot of network cables back in the day. I have the tools/skills, I just hate those connectors. Home-Made, Pre-Made, or otherwise. I also don't want to have to unsheath a pre-made cable if I don't have to. Plus, a pre-made cable will end up costing almost as much as a big bag of connectors and won't end up lost in my bin-o-cables to be thrown away in 15 years when I finally dig through them. 🙂

Hello Ian,
This was my First Post on this Board. With your last Response you are telling new Users to never Post anything here again and more Important, to never buy Duet Hardware again.

I will now jump over my shaddow, create those 5 new Threads as you suggested and Hope for a similar Response there.

With best regards
Benjamin

Glad to help. I ran a large forum for a while and the level of google indexing and such that leads people to a solution is usually worth coming back for.

@elmoret said in PWM Fan 1 Output not working:

@droftarts said in PWM Fan 1 Output not working:

@T3P3Tony and @dc42 have agreed to a warranty replacement.

Where did they do this? I do not see such confirmation in this thread.

I have that power! Mwaaaahhaahahaha....

Ian
(Part-time Duet 3D purveyor of tech support / documentation scribe / firmware test mule - but don't tell everyone!)