Topics created by Karim

@Phaedrux ok I change the Z value in M208 S0 Z118.17 in config-override.g and then restart to get the nozzle closer to the bed. I will test and report back the evening.

@Karim post you config and homing files

@Phaedrux thank you, I got it working I replace the SD card.

@Phaedrux lowered Z speed. Sounds better now.
Thanks.

@Phaedrux
It looks good now. This is 250x250mm.I did not change anything in the slicer. I don’t know if the G92 X0 Y0 fix it.
X282 Y310 Z275 is my bed size in my slicer

4A3782C9-EC0F-46EA-81D2-9533084C363A.jpeg

@jay_s_uk Hey I got it working, But the Z offset is a little different.

Thanks guys.

@Phaedrux Got it working, Thank You.

@cosmowave Got it working on E2.

Thank you

; LEDs M950 H2 C"nil" ; free up e2_heat pin M950 F3 C"duex.e2_heat" M106 P3 S255 B0 H-1 C"Top Lights" ```.

@Phaedrux thanks that work.

@Phaedrux thanks guys.

@dc42 Thank You

Nevermind I see you have a dedicated thread. Assuming your homing is now working for you I'll mark this thread as solved.

@Phaedrux

;E3d Revo Voron) M308 S1 P"e0temp" Y"thermistor" T100000 B4725 C7.06e-8 ; configure sensor 1 as thermistor on pin e0temp M950 H1 C"e0heat" T1 ; create nozzle heater output on e0heat and map it to sensor 1 M307 H1 B0 S1.00 ; disable bang-bang mode for heater and set PWM limit M143 H1 S280 ; set temperature limit for heater 1 to 280C

@oliof thank

Disregard, I got it working.

I got it to update, I had to update to 3 then 3.2.

Thanks Guys, Everything look good.

Duet wifi