Best posts made by Karim

Ok, guys think I found the source of the problem. The connector that I made for the T0 was not tight so it was shaking when printing which creates a short inside the connector. So after about 6 hours of printing everything looks good.

Finish Print

I need to calibrate my extruders and Tune cura.
Cura
Polymaker 2.85mm PolyLite PLA Filament Translucent
.6 Nozzle
.3 Layer Height
10% Infill.
This was print at 150% scale.
https://www.thingiverse.com/thing:2849214

The Hotend (T0) Connections. This shows the new connector.

@cosmowave Got it working on E2.

Thank you

; LEDs
M950 H2 C"nil" ; free up e2_heat pin
M950 F3 C"duex.e2_heat"
M106 P3 S255 B0 H-1 C"Top Lights"
```.

Thank you, Everything seem ok.

I got it to update, I had to update to 3 then 3.2.

@jay_s_uk I got the 24v on order too, but it will ship mid December, when I get home I will work on it.

@Phaedrux

;E3d Revo Voron)
M308 S1 P"e0temp" Y"thermistor" T100000 B4725 C7.06e-8      ; configure sensor 1 as thermistor on pin e0temp
M950 H1 C"e0heat" T1                               ; create nozzle heater output on e0heat and map it to sensor 1
M307 H1 B0 S1.00                                   ; disable bang-bang mode for heater  and set PWM limit
M143 H1 S280                                       ; set temperature limit for heater 1 to 280C

@jay_s_uk Hey I got it working, But the Z offset is a little different.

Got it working, you don't need a level shifter, 3.3v works for the signal, it's only 3 neopixel

M150 X4
M150 W255 P255

@Phaedrux lowered Z speed. Sounds better now.
Thanks.

@Phaedrux thank you, I got it working I replace the SD card.