Topics created by jamaicarasta

@jay_s_uk Thanks for your help man, now the Test print. That was the Print yesterday without shaper. 100mm/s and 7000accel. Not bad with 7000accel. Voron 350 with lgx lite and carbon x axis and 1 mgn12 rail.
IMG_3887.JPG

@stephen6309 and my first print with cura was better than superslicer 👌
I will try it tomorrow with a few prints.
greetings from germany

@daveh hey thanks, the bondtech webside have already found.
I'll take a look at the other link.

@jamaicarasta said in Switch from 3.3 to 3.4RC2:

I'm interested in whether the config is fresh or my old one.

Always keep a copy of a version which works, so you can revert to that if some new installations, configuration changes etc. don't run as expected. I understand that you now have a trusted setup with RRF 3.3 - keep a copy of this state before you install 3.4. I even make copies of the SD card before I fiddle around with the config or my macros, not only in the event of a new firmware version.

@jamaicarasta glad you got it sorted! so its all up and running properly now?

Measure your offsets: https://docs.duet3d.com/en/User_manual/Connecting_hardware/Z_probe_testing

Alter your grid size to take into consideration the physical offsets. Skipping points it can't reach isn't necessarily a problem, but it does mean you could have a more efficient usage of points. Though if you're not using the maximum 441 points, does it really matter?