@jay_s_uk
ok i will check that i took a config from the internet from the beginning and maybe the value there is wrong for my probe

@jay_s_uk
Ah ok. Xmotor1:motor2:motor3:motor4 Ymotor1:motor2:motor3:motor4
You are my hero
I hope I can ask you a few more questions in the near future. I still have a few things I don't quite understand.

@jay_s_uk Thanks i will try it

@jay_s_uk ok
I will try M593 P"MZV" F41 and make a test print.

@jay_s_uk Thanks for your help man, now the Test print. That was the Print yesterday without shaper. 100mm/s and 7000accel. Not bad with 7000accel. Voron 350 with lgx lite and carbon x axis and 1 mgn12 rail.

@jay_s_uk Thanks for your help man, now the Test print. That was the Print yesterday without shaper. 100mm/s and 7000accel. Not bad with 7000accel. Voron 350 with lgx lite and carbon x axis and 1 mgn12 rail.

@jay_s_ukDo I understand that correctly, nothing is required in the system files. The M593 P"zvd" F46 command in the config file is sufficient.

@jay_s_uk yes first try without your tips

@jay_s_uk and can i delete the acc file in my system?

@jay_s_uk ok i understand, i must activate the hook when i change the center frequency

@jay_s_uk ok
I will try M593 P"MZV" F41 and make a test print.

@jay_s_uk ok,but with the command M593 I enter the value 41hz which is displayed in my file on the left, right? But where is the center shaper entered?

@jay_s_uk and what is the center shaper hz?

@jay_s_uk Ok, what is the fastest shaper? than i will try it first with a test print

@jay_s_uk Ok first test with none, than look what is the flattest curve?