Best posts made by Gianluca

@droftarts
After many attempts and many tested CAN-FD cables, I was able to get the locked Toolboards working.
It was definitely the faulty cable. it was cut off about halfway down the length and was making false contact.
I managed to restore the two original 1LC cards and also a clone that I had purchased for testing.
The quality of the cables is very important!

Thanks, you can mark it as resolved.

I solved it, I found the correct plugin for 3.5.0.RC1 in https://github.com/MintyTrebor/BtnCmd/releases/tag/01.02.06.
100% installed and working.
Thanks to jay_s_uk for the advice.

You can mark as resolved.

Thanks for your help !
Problem 2: With “T0” to the end of config.g all work perfect.

Problem 1: I find the problem: now work all good !!!

; homeall.g
; called to home all axes
G91 ; relative positioning
G1 H2 Z5 F6000 ; lift Z relative to current position
G1 H1 X-235 Y-228 F3000 ; move quickly to X and Y axis endstops and stop there (first pass)
G1 H2 X5 Y5 F6000 ; go back a few mm
G1 H1 X-235 Y-228 F240 ; move slowly to X and Y axis endstops once more (second pass)
THIS IS TE PROBLEM !!! G1 H1 Z-255 F240 ; an old command in RRF2
G90 ; absolute positioning
G1 X110 Y110 F3600 ; Posiziono la sonda al centro del piatto
G30 ; Sondo il piatto con il BLTouch
;END

Thanks again !

@jay_s_uk said in DWC UPDATE PROBLEMS WITH NEW DUET 3 6HC:

@gianluca sounds like a cache issue. try clearing the cache or a different browser to confirm

Yes, it could be a Firefox error... in addition, I also have an error on the execution of DWC the internal plugins, this evening I write exactly the error found ...
I also did various tests with SD of different sizes and with various formatting mode.

Great, now everything works as I wanted. The indications received were perfect. You can mark it as solved, thanks!

Hi Peter,
I am very interested in your work and would like to try it.
Unfortunately I can't install your plugin on my system.
I have downloaded the file "PrintWatch-3.4.2.zip" ver.1.0 but there are compatibility problems, with the latest firmware version 3.5.0.RC1.

Are there any suggestions for a successful installation, or will other versions be released?

@Peter-Lebiedzinski said in AI Print Monitoring / Printer Health monitoring:

@Gianluca
We have created a ZIP installer for the 3.5.0-rc.1 versions of RRF/DSF/DWC, it can be found here: https://github.com/printpal-io/DSF_PrintWatchAI_Plugin/releases/tag/v3.5.0-rc.1

Please note that the 3.5.0-rc.1 currently has an issue with the HTTP endpoints being registered. This can be easily worked around by doing the following:

• Make sure the plugin is installed and started
• SSH into the SBC
• Enter the command: sudo systemctl restart duetwebserver

This will restart the webserver and register the endpoints correctly. This must be done every time the SBC is started up. This should be fixed in the next release.

Thank you so much for your precious help. This evening, after work, I will do all the tests and update you. I'm sure others who have installed the latest firmware version will find your work very useful!

@MintyTrebor
When will a DWC 3.5.2 rc1 compatible version of BtcCmd be released?
Unfortunately BtnCmd 01.03.01 does not work with DWC 3.5.2 rc1.
Thank you