it may be stripped out my coupler... because my threaded rod is rising... ordered some new couplers. will test wednesday

@bearer its all inside a case dangit... lol

Good morning... So yesterday as I was toying with ending gcode etc I think i wanted to try out the sleep command.
Woke up this morning after a print had finished and cant connect to my duet. Powered it off, back on again, nothing.
Is this normal behavior? Just curious as to why suddenly ive lost wifi access to it.
3.1 fw version , duet wifi board.
thanks

well, the default is turds that seemed to have resolved it. keep u posted.

not sure how 4000 got put in there.. but that would explain why this thing when asked to move up 5mm goes up lets see about 10x that haha

whats odd though is the nozzle is perfect when z is at 0. its only after the print starts does it raise up. Its like the gcode from the slicer is telling it to move up.
But here is the first bit of gcode.

I know its exactly -3 to where I need to print.
So can i just modify that G92 Z0 to be G92 Z-3?

thank you kindly for the help

@Phaedrux i was missing the M501 printing happily away now..
The only outstanding issue now is the fact that my printer automatically goes up 3mm (default) before it starts printing. So its air printing.

i can mod the Z offset in slicer settings, but id rather add it to firmware.
Should be fairly easy, but I am not smart in these ways haha
thanks for the 501 help

Ok, i went ahead and rebuilt it.
Everything wrks except the bed heater.
its a slow bed heater, so its throwing a fault.
Ive tuned it, and made this change.
Still happening though... any ideas?
thanks

Yeah, i was afraid of that... I just have a problem knowing all the right stuff for the configurator...
The config I have there is mostly a copy/paste (to some extent) of my version 2 config.. so yeah clearly something is amiss.