Your browser does not seem to support JavaScript. As a result, your viewing experience will be diminished, and you have been placed in read-only mode.
Please download a browser that supports JavaScript, or enable it if it's disabled (i.e. NoScript).
?
@dunginhawk if you have a paneldue you can try running gcode from there to troubleshoot the wifi (M552) but its takes a while to work with the touch keyboard as well.
(consider adding a short panel mounted micro usb extension cable for the future)
undefined
well, the default is turds 🙂 that seemed to have resolved it. keep u posted.
To aid the setting up of the Precision Piezo(s), I replaced the single turn potentiometer, with a multi turn type.
This gives far greater control of sweet-spot settings, and ensure I get consistent repeatable reading across a 300x300 mm bed.
so yeah, i think that fixed the issue... Ive been printing most of the day now without issue... Im doing retraction testing now...
the Y was just moving opposite when I homed it... so i reversed it.. we shall see 🙂 prints are looking good though.
And yes, the bed is all the way back against endstop, and X is left, so 0 0 is front left 🙂
Hi @dunginhawk,
did you change de Z step?
My E step is for the SEEMECNC EZR, what extruder are you using?
