Quick questions regarding 3.6.0 Beta.2 on a DUET6HC
Are the M260.1/M260.2 commands available on this beta version as stated in the doc ?
If YES: May I use simulateously
1-DuetWebControl through wifi for console operation
2-io0 serial IO connected t to a custom CNC-Pendant like board
3-io1 serial IO connected to an adapter talking to a modbus device (BLDC controller)
io0:I would send gcode command (M105, M409.... GXXX) through io0
io1:General idea is to keep spindle section electically isolated from DUET to avoid mass loops, since currents (both DUET 48V with NEMA23) and 400W BLDC are pretty high and cabling is quite complex, while having complete gcode control over BLDC (speed, CW/CCW, stall ....)
What is the max baud rate for each interface when used ?
is there any bottleneck/precaution to use this somewhat serial IO demanding configuration?
Of course I will carefully test all this and report any issue and/or success.
If NO or partially available, how long will I have to wait (project planning, I have no killing deadline ) ?
Many thanks for your help
