Printer don't heat after longer in IDLE state 3.4b7+1

kr15_uk

Haven't tried to do next job earlier than 30mins after 1st finished, I'll see if I can spot next print finish to test straight away.
Both, although I haven't tried cold bed print, always both heaters are on.
Just M104 and M140 to zero, XY home and M84
This is fairly new build so it's as generic as it gets out of online configurator.

On the previous post of mine, after downgrade to 3.4.0b6 on Duet 2 WiFI it works fine and 3.4.0b7 Duet 2 Ethernet has the same issue.

Ta

Kris

SIam

@dc42 My printer was 9 hours in idle state without a print job and the heating works

Alex.cr

@dc42

Basically, if the temp of the hot end goes below 18C or so. If I remove power for 24+ hours and then fire the machine up it will occur.
Mine just effects my hot end on my 1LC. My bed heater on my 6HC works fine.
Yes to all 3 questions.

4.stop.g

G1 E-3.0  F1500              ; clear extruder
G91                     
G1 Z5.0  F20000               ; move Z from part
G90
M104 S0 		; Extruder heater off
M140 S0 		; Bed heater off
M141 S0         ; Chamber heater off
M106 P3 S0      ;turn off lights
M106 P2 S0      ;turn off MCU fans
M106 P0 S0      ; Turn part fan off
M106 P6 S0 ; turn off Nevermore fan

M220 S100		; Set speed factor back to 100% in case it was changed
M221 S100		; Set extrusion factor back to 100% in case it was changed

M98 P"/macros/print_scripts/goto_bucket.g"    ;go to park position over bucket

MikeDC

I finished a long print around 3 hours ago today and left the printer idle afterwards.
I have just tried another print,
My main contactor does switch on but the bed is not heating.
i cancelled the print and thought i would do a couple of tests.
I can heat the nozzle manually and disable the nozzle heater
I have full control of it from both paneldue and dwc

the bed heater no control on temperature
i can manually turn the contactor on and off both by the paneldue and dwc
i can appear to enable / disable the bed heater
but it just doesnt heat up.

Only a full power reset will allow it to work again

dc42

@mikedc This is fixed in 3.4.0beta7+4, see https://forum.duet3d.com/topic/26787/unofficial-rrf-3-4-0beta7-2-files.

MikeDC

@dc42
is this a different b7+2 to what i am on ?
I used b7+2 to fix the z on expansion card issue but i still have this issue with bed not heating up after idle

jay_s_uk

@mikedc yes. the latest builds on that thread are now 3.4b7+5

MikeDC

@dc42
ahh now b7+4 thankyou :)))

I will install after my print has finished

SIam

@dc42 It looks good ! Thanks for fixing this issue

bastien

for me, b7+4 don't resolve problem

Fred-Y

@bastien New version have been published since b7+4, I believe the last one is +7
I don't remember having this error lately.

You should be able to download b7+7 from here:
https://forum.duet3d.com/topic/26787/unofficial-rrf-3-4-0beta7-4-files/17?_=1642785164011
Need to scroll to get the link.

bastien

it's ok with b7+7, thanks