Toolboard

[dc42]

@auré is the red status light on the tool board flashing slowly in sync with the one on the main board? Or flashing quickly? Or not flashing at all?

[Auré]

@dc42 said in Toolboard:

@auré is the red status light on the tool board flashing slowly in sync with the one on the main board? Or flashing quickly? Or not flashing at all?

The red status light on the Mainboard flash slowly and on toolboard quickly

[dc42]

@auré in that case it doesn't have CAN sync. Verify this by sending M115 B121 to see whether you get a timeout message. If so, then most likely you have a bad CAN cable, or you have CAN_L and CAN_H swapped between the ends.

[Auré]

@dc42 said in Toolboard:

in that case it doesn't have CAN sync. Verify this by sending M115 B121 to see whether you get a timeout message. If so, then most likely you have a bad CAN cable, or you have CAN_L and CAN_H swapped between the ends.

Yep I have already use this command

[dc42]

Note that you can also fail to get CAN sync if you have mismatched firmware versions on the main board and tool board; but if the only problem is mismatched firmware versions then most commands will still work including M115 B121.

[Auré]

@dc42 said in Toolboard:

Note that you can also fail to get CAN sync if you have mismatched firmware versions on the main board and tool board; but if the only problem is mismatched firmware versions then most commands will still work including M115 B121.

For test I change the can l and can H and now the led red statut flash slowly and I send M115 B121 and I'm really sorry I was sure of me

[dc42]

@auré I'm glad you managed to fix it.

[Auré]

@dc42 said in Toolboard:

I'm glad you managed to fix it.

Thank you for your help I search now how to know the motor turn in the right way.

[dc42]

@auré See the M569 command.

[Auré]

@dc42 Thanks!