ethernet to esp breakboard

[CNCModeller]

@apak said in ethernet to esp breakboard:

@cncmodeller sure, I will post the gerber so you can order as much as you want

That's brilliant, thanks!

[alankilian]

@apak If you ever want to do this kind of thing again, you might want to use these surface-mount 0.1" header pins.
https://www.digikey.com/en/products/detail/oupiin/2015-1X40G01DBB/13251225

That way you could make the board just as big as the WiFi module instead of making it twice as big.

This is awesome project. Congratulations on getting it working.

[apak]

@alankilian so I just solder those on the botton layer and the esp07s on top, nice, lest see if the footprint is available at easyEDA

[apak]

@cncmodeller https://easyupload.io/j3zvfh this is actual prototype

[CNCModeller]

@apak that's great thanks.

Will the surface mount headers idea still allow the ethernet module to fit if required?

[apak]

@cncmodeller sure, why not?

[CNCModeller]

@apak said in ethernet to esp breakboard:

@cncmodeller sure, why not?

I only ask as the ethernet headers on my Duet are 1/height.

[dc42]

@apak said in ethernet to esp breakboard:

Do you think that I could get any trouble using this board?

It will almost certainly generate more EMI than the on-board WiFi module, so getting CE certification for a printer using it might be difficult. Other than that, I don't see any problems. The critical traces to keep short are the ground traces and the SPI traces.

[apak]

@dc42 in that case I will try this breakboard, shorter pads

[o_lampe]

@apak
The positions of some 'vias' are pretty close to adjacent pads. The routing could use some cleaning...

[apak]

@o_lampe I have no tecnical education, I used the autoroute feature. Already ordered.

First pcb disconnects from wifi once you start to print....so DON´T use first PCB

[jay_s_uk]

@apak have you included any resistors that may be required?

[apak]

@jay_s_uk nope

[jay_s_uk]

@apak i suggest you review the schematics.
I don't know what resistors aren't included onboard when its the ethernet module and some may be required to be added on certain lines.

[apak]

@jay_s_uk don´t see any, looks like direct pin contact between "comm alternate header" and ESP pins

[jay_s_uk]

@apak what about these ones i've highlighted in red?
These are the ones that probably won't be there on an ethernet board.
I only have wifi boards here so can't check.
maybe @T3P3Tony or @dc42 can comment?

[dc42]

The other thing that may be missing on an Ethernet board is the 74HC74 chip. However, if you use wifi firmware 1.24 or later then you can bypass it by installing R82.

[apak]

@jay_s_uk all that should be already on the duet board, we are talking to direct pin contact between alt comm ports and the esp solder traces...

At this point I point out that I have just converted ethernet clone boards to esp-07s so far with no trouble, but soldering the esp to the board traces

[jay_s_uk]

@apak fair enough. It's just not what the schematics implies

[apak]

@apak
seems everything is in place, also the 74HC74

guess that the chinnese clons just install everything for the wifi version and then just plug the ethernet board