Z-probe triggers way above table during HOME ALL

[Billsrf]

@phaedrux 1_1555973271826_homez.g 0_1555973271825_homeall.g

[Phaedrux]

That all looks right to me.

Do you have anything weird in config-overide.g?

[Billsrf]

@phaedrux 0_1555973721313_config-override.g 0_1555973742894_bed.g

[Phaedrux]

That all looks fine as well.

[Phaedrux]

Firmware version?

Double check wiring? Bad crimp? Clean the sensor with some isopropyl?

[Billsrf]

@phaedrux

[Billsrf]

@phaedrux do you have a link to the latest update?

[Phaedrux]

https://github.com/dc42/RepRapFirmware/releases/tag/2.02

[Billsrf]

@phaedrux thank you, I will update today and check for hardware issues

[dc42]

@billsrf said in Z-probe triggers way above table during HOME ALL:

@dc42 went through the same set up process as described in test and calibrate Z probe, same results as before, it moves down 10 mm then triggers then stops. I did nottice, as it is moving towards the X-Y home position, the IR sensor flashes 3 times like it is just initialized. Never done that before either.

Perhaps you have a bad crimp connection in the sensor cable, so that one of the 3 wires disconnects at certain XY positions?