@steviegregory said in Can’t store heater fault details in returned message:

@owend Is it possible to do this on RepRap 3.1.x, before the addition of events in RepRap 3.4?

No.

@dc42 this is the problem, thank you. I will try to repair it

@Marcelofs13 said in Duet 3 busy after homing all:

RepRapFirmware for Duet 3 MB6HC version 3.01-RC9

please update to 3.2.2

@jay_s_uk said in Endstop with duet3:

stop.g

Make sure to include M0 at the end of your job so that stop.g is called.

@Phaedrux Alright, thanks.

@wifibeagle that can easily be incorporated though as endstops can be changed to triggers at the beginning of a job.
Or you can permanently have them set up as triggers and change them to endstops at the start of the homing sequence and then put them back as triggers

@Phaedrux said in Issues setting up duet 3:

@CaLviNx @deckingman Do we need to create a forum for old farts to snip at each other?

Excellent idea! I guess now that you've called me an old fart, you'll want to join too.

i'm sure there are lots of other options, but https://www.raspberrypi.org/documentation/usage/audio/

(and https://forum.duet3d.com/topic/13194/dsf-extension-exec-on-mcode-was-shutdown-sbc of that wasn't obvious)

@Xavier works thanks!

@Danal
The heater erratic behavior is on the configurator page only at https://configtool.reprapfirmware.org/Mapping
It's perfectly fine on the printer itself! I actually managed to finally get a calibration cube out of it 😄

Thanks for confirming the case of M500.. Yeah 😛 I ended up doing the M307 for H0 and H1 by hand and filling them up there and then doing the M665 and M666 as well. (I'll move them to the config.g since they don't really need to live in the override either.)

So far so good!

I'm all new to RepRapFirmware and coming from old Repetier 8 bit world. 😆

@bam @sylvaindc Hi sorry I've not replied earlier, do you guys still need the files or some adjustments done?

@bearer said in Duet3 setup requirements for 3D printer:

Slightly OT, but as the Pi image has a FAT /boot partition it could possibly contain the default standalone config and files so the same card could maybe cover both use cases.

That's really clever.

@dc42 said in Duet 3d did not consider:

We are also looking at including encoder interfaces on some boards so that we can do closed loop control.

That will be sweet

Awesome. I’m running a bit older version on my main machine that doesn’t have it, but it’ll be nice to have when I finish the Duet 3 upgrades.