DUET WiFi E0 / E1 no workie - config?
-
for the extruder to work the hot end must be 160deg or you could use a M302 to allow for cold extrusion.
-
Yes, this machine will be doing cold extrusion exclusively.
Where would I enter the M302 value? -
Put it at the end of your configuration file.
-
XYZ steppers appear to be energised and have LEDs on.
That, and I know they work since I can control them through the GUI.Does the LED for E0 / E1 only light up if extrusion is called for in gcode?
How can I test the E0 / E1 steppers to know that they are working /wired correctly?
Is there some gcode I can load to test them? -
@nurbie said in DUET WiFi E0 / E1 no workie - config?:
Does the LED for E0 / E1 only light up if extrusion is called for in gcode?
LEDs are for the ends stops (and the two other E0/E1 leds are for the FETs)
-
How can I test the E0 / E1 steppers to know that they are working /wired correctly?
How do I control them through the GUI/terminal?
Any tests/ideas?
-
If you were to look up the M302 command you'd find you also need to specify which extruder to allow cold extruding for.
https://duet3d.dozuki.com/Wiki/Gcode#Section_M302_Allow_cold_extrudes
-
@nurbie said in DUET WiFi E0 / E1 no workie - config?:
How can I test the E0 / E1 steppers to know that they are working /wired correctly?
How do I control them through the GUI/terminal?
Any tests/ideas?
Select a tool that has an associated extruder. Either set that tool to have no associated heaters in your M563 tool definition command, or enable cold extrusion. Then the extruder buttons in DWC won't be greyed out.
-
YES! Gracci dc42!
M563 P0 D0 S"LDM_01" did the trick! now testable via GUI.
Should there be a Duet LED (proximate to the connector like XYZs) showing that the E0 is energized?M302's not sure if they made any changes but added them as backup.
NOW, on the getting the FSRs recognized by the Duet . . . (that's another forum post)
M563 P0 D0 S"LDM_01" ; create a named tool using extruder drive 0
M558 P5 X0 Y0 Z0 H15 F200 I1 ; FSR Settings
G31 P500 X0 Y0 Z-0.3 ; Probe trigger value and offsets
M270 I1 P1 S0.05 ; Enabled Probe doubletap w/ 0.05mm tolerance
M557 R140 S30 ; default bed mapping
M501 ; Load saved config values
T0 ; Select Tool 0M302 ; Report current state
M302 P0 ; Allow cold extrusion
M375 ; Load height map -
@nurbie said in DUET WiFi E0 / E1 no workie - config?:
Should there be a Duet LED (proximate to the connector like XYZs) showing that the E0 is energized?
Only if the heater or endstop is active.
-
thanks m8
