Voron 2.4 duet 5 mini pauses every 12 seconds when printing
-
Hi guys,
I'm running RRF v3.5.4 on Voron 2.4 300 mm with duet 5 mini and SHTv3 toolboard. Xol toolhead with orbiter v2 extruder. Prusa Slicer is used to slice models.
I've noticed that printing staggers every 12 seconds or so - first thought was this was to let layer cool, but that was also visible on printing infill on large-ish prints as well.
SD card was changed and that had no effect (both old and new were able to produce 40mb/s reads and 10mb/s writes.
I've tried bumping up acceleration but that seems to have no effect as well. My bed compensation is tapered (over 6mm), however, pauses were also visible on layers higher than 6mm, suggesting that this is probably (don't take my word on it) not related to low acceleration for Z axis.
Attached are M122/M122 B124 outputs and my config along with gcode file.
Where/what can I look at next?
config.g.txt
M122B124.txt
M122.txt
v13_top_panel.gcode -
Can you try disabling the heightmap? Usually this would be a sympton of the Z axis having too low a jerk value, but that may not be the issue here.
Is there any commonality to the pauses?
