Genuine BLtouch 3.1 no output
-
@ageis said in Genuine BLtouch 3.1 no output:
It just doesn't make a difference to the value in the Z column.
You're unlikely to see any change displayed in DWC since the BLTouch triggers and instantly resets itself. Your best bet to see if it's functioning is to follow this guide: https://docs.duet3d.com/en/User_manual/Connecting_hardware/Z_probe_testing
-
@ageis Can you issue the commands that deploy and retract?
-
@fcwilt
Thats just it, I can. Thats what's got me confused.When I issue M280 P0 S10 it extends and the led switches off.
When I issue M280 P0 S90 it retracts and the led turns on.
confused!
Just no response on the output. I have buzzed out the black and white wires. Just in case it's my dodgy crimping but they seem fine.
-
@ageis That leaves a bad input or the wrong input? Quadruple check you are connected to the correct pin and using the correct pin name.
-
Does M401 and M402 work to deploy and retract?
Have you actually tried a G30 to see if it deploys the pin and trigger the pin by hand to see if it stops movement?
-
@Phaedrux
both M401 and 402 does nothing. but M280 P0 S10 and M280 S90 works.I noticed the pin doesn't get deployed when executing G30 or a G28.
It should deploy the pin when I do a G30 right? -
@ageis said in Genuine BLtouch 3.1 no output:
both M401 and 402 does nothing.
Then your deployprobe.g and retractprobe.g either haven't been created or don't contain the correct commands. Or maybe they aren't in the right spot. They should be in the sys folder.
-
@ageis I seem to recall that for the M commands to work you need to create two files deployprobe.g and retractprobe.g and put the appropriate servo command into the file.
-
@fcwilt
Yeah I skipped that step by mistake. Rushing through things yet again. I never learn.It works now.
Many Thanks to @fcwilt and @PhaedruxThe bltouch appears to be repeatable so far. The 5 trigger height measurments I did were all +/- 0.1mm of each other.
My chinese sister invented a good product. I believe the engineer that invented the BL TOuch was female and chinese. Unless the picture i saw was just a representive. I hope I can finally get a consistent first layer. Not 0.3mm on one side then barely anything on the other side.
-