LIS3DSH orientation on a Delta printer

[Velvia]

@dc42 You were right. It works now. Split the CS cable and ran it far away from everything else. Was able to make measurements now. Thanks!

Are there shielded ribbon cables available?

[dc42]

@Velvia said in LIS3DSH orientation on a Delta printer:

Are there shielded ribbon cables available?

Yes, however I have used unshielded ribbon cable successfully with these boards. If you use a 10-way ribbon cable and IDC connector to plug into the daughter board connector, then spi.cs1 can be used for CS because it is on the outside of the cable and the adjacent wire is ground.

[blt3dp]

I'm planning on using a shielded guitar wire for the cs wire when i wire mine up.

[Velvia]

@dc42 I was able to get three readings, but now every time I try to get readings, it freezes the mainboard and it restarts.

[dc42]

@Velvia which firmware version are you using?

[Velvia]

@dc42 3.4.1

[Phaedrux]

@Velvia said in LIS3DSH orientation on a Delta printer:

@dc42 3.4.1

Update to 3.4.5?

[Velvia]

@Phaedrux Thanks. I do that by running "M997 S0:1", right? Been a while

[Phaedrux]

Upload this zip file to the system tab in DWC.

https://github.com/Duet3D/RepRapFirmware/releases/download/3.4.5/Duet2and3Firmware-3.4.5.zip

[Velvia]

@Phaedrux Thank you for the help. Now I run as many times as I want, even with the Input Shaping plugin. No more crashes!