Resurrect.g questions

[modl]

Hi everyone, I would like the resuming of a print after an accidental switch off or blackout to be automated. It needs to work of the power has been shut or the print paused multiple times in a row. I guess I can call M916 in config.g if resurrect.g exists. But in order for it to not trigger when i start a new print, it means i should delete or rename resurrect.g at the end of the print ? Or rename it right after it has been executed ? Both ?
Also I'm not very good at electronics and would appreciate if someone could explain to me how to wire the capacitor as per this statement "Adding a 10000uF capacitor across the VIN rail can help increase the amount of stored power " in https://docs.duet3d.com/en/User_manual/Tuning/Resume

I have tested my setup and the resurrect seems to work, it seems like i don't need to home z as my lead screw has a 2mm pitch, i'll need to tune the settings and maybe add a high endstop to z but i'm not to worried about this part.

Thank you in advance
Best

[dc42]

@modl when a print completes normally, any resurrect.g file that was created is deleted automatically.

[modl]

@dc42 That's good to know thank you !

[FreakOnLeash]

Hi, i have SKR3EZ + BTT UPS 24V V1.0 in standalone mode and can't set it up correctly. I did all settings like in https://docs.duet3d.com/en/User_manual/Tuning/Resume, but it doesn't work.
When power turns off it just stops in place and M911 didn't write to the resurrect.g.

[Phaedrux]

@FreakOnLeash Probably best to start a new thread and share some more information about your setup.