execonmcode no longer working with 3.4

[MartinNYHC]

I'm using execonmcode to shut down the printer after nightly prints. With 3.4 it doesn't work anymore.

/var/log/daemon.log:Mar 21 23:08:35 voron2 DuetControlServer[3357]: [error] M7722: exit status 7:
/var/log/daemon.log:Mar 22 20:24:45 voron2 DuetControlServer[2480]: [error] M7722: exit status 7:
/var/log/daemon.log:Mar 22 20:25:17 voron2 DuetWebServer[569]: DuetWebServer.Controllers.MachineController[0] [DoCode] Executing code 'M7722 A"Shutdown"'
/var/log/daemon.log:Mar 22 20:25:39 voron2 DuetWebServer[569]: DuetWebServer.Controllers.MachineController[0] [DoCode] Executing code 'M7722 A"Shutdown"'

Any ideas? Thanks.

[CrazyCreator]

works for me with no problems

[MartinNYHC]

Mhhhh....I don't changed anything except upgrading to 3.4 via SBC.

[Rushmere3D]

@martinnyhc Have you reinstalled it? I've found updating firmware breaks the link and after following the install guide it works as it did.

[MartinNYHC]

@rushmere3d Nope, but will try. Thx.

[MartinNYHC]

After a reinstall it works again Thanks.