New hemera settings
-
I also moved the benchy to a div spot on the build platform
Also ran the same slicer program from laptop to rule out slicer. ????
Im baffled running out of things to check and ideas -
Current rating is 1.33amps is it possable this js where my prob is extruder ma???
-
Extruder current??
-
you are running at 950 which is about 70%. that should be fine
-
@ziggymanpopo said in New hemera settings:
The prints keep improving but cant seam to get rid of the large error on the bow
Anyone have any idea what caused ithttps://help.prusa3d.com/en/article/the-benchy-hull-line_124745
Try some different test print models.
-
Hey phaedrux... Thank you for the benchy link ..That explains it.. see the pick.... it ptinted fairly well i couldn't explain the lines at all now i understand
You will notice the missing lines on the tray
To complicate the analysis, the hamera i got is one of the miss mached gear ones (3%of one run had this ) guess I'm one of the lucky ones ??
I was testing feed rate and heard the extruder start popping the gears at a 30mm per sec. feedrate ..
With your benchy link i beleave i have an awnser
Thanks Again. Ed
-
Cute dice tower.
-
Like yours beter
-
It's a nice model. https://www.thingiverse.com/thing:3433643
-
@Veti said in New hemera settings:
who is pushing the pt100? i just said that e3d does not sell them.
E3D does normally sell them, but is showing sold out at present. https://e3d-online.com/products/pt1000-temperature-sensor?_pos=7&_sid=ac5fe10a2&_ss=r.
There are several other sites selling PT1000 sensors compatible with E3D heater blocks.