@dc42 Thank you for your reply!
I will lower the motor current to 600 with RRF and upload the zip file to Duet.

@celulari
This is the app, after an initial look I also upgraded to the paid version.

IMG_20210617_190236.jpg

https://play.google.com/store/apps/details?id=com.morganandwife.vibration

@jay_s_uk
Thank you for clarifying my issue.

Cheers
Bengt

@phaedrux
Hey Phaedrux, re-flash worked; got an IP address/DWC. I'm learning. Til next time,

**THANKS!!!**

5 axis to move the tool and I will have some tools that will require 3 steppers. I also planned to have a stepper that would open an enclosure

@mrehorstdmd why not look at neopixel support now its been added for the duet 2? I think the limit is something like 60 or 80. Would this be enough?

@tecno said in Bedlevel issues:

So what you say is to change M671 ?
from M671 X-45:445 Y200:200 S5 ; Define positions of Z leadscrews
to M671 X445:-45 Y200:200 S5 ; Define positions of Z leadscrews

No, see here for the pre-requisites: https://duet3d.dozuki.com/Wiki/Bed_levelling_using_multiple_independent_Z_motors

@tecno said in Bedlevel issues:

G1 H2 X5 Y5 F6000 ; go back a few mm
G1 H1 X-405 Y-405 F240 ; move slowly to X and Y axis endstops once more (second pass)
G90
G1 H2 X200 Y200 F3000

Remove the H2 from the X Y moves. It's really only appropriate for the Z moves to allow it to raise for clearance before the Z axis has been homed.

Thank you both, like I expected, embarrassingly simple.

what filesystem did you format the sd card with?

@tristankoeln said in can't enable endstops in corexy:

M574 X S4 M574 Y S4

I think you want S3, not S4

@dc42
@OwenD
@theruttmeister

Thank you! This gives me a good starting point.

@phaedrux apparently their development team does not print unmodified nylon as they think a raft will suffice to adhere nylon to bed surfaces. 😒

@falkia Thanks, you make it sound possible.

Now let´s see what on earth VPN stands for and how to set it up 😄

Please post the results of M122 and M98 P"config.g" please.
Does the firmware version between the two duets match?

Post your homeall

@cosmowave As I understand it, is that if the user presses cancel the macro is aborted, so just make an infinite loop and put M291 in it.

Please send an email to warranty@duet3d.com and CC your reseller. Include a link to this forum thread and the details of your original purchase. You'll receive a reply with a form to fill out.

@droftarts

Once I figure out a way to neatly enclose all this new hardware I'll definitely do that. Right now its all bolted to the old CR-10 enclosure skeleton haha..

@mathv said in Trouble connecting Toolboards 1LC to Duet 3 6HC:

@dc42 Thanks again.
I will purchase the ATMEL ICE and try this procedure keeping the bootloader.

There's no real need for an ICE unless you want to modify and debug the firmware.

Thanks @giostark, that's great. In fact it's just the sort of thing I wanted to know. So I take it from that the bed.g holds the mesh point locations.

I'm printing on a mirror, on a flat bed levelled at 3 points, I just need to allow for inaccuracies in the bed plane.

Many thanks
Barry M