@phaedrux
Hey Phaedrux, re-flash worked; got an IP address/DWC. I'm learning. Til next time,

     **THANKS!!!**

My initial pursuit was a Ballscrew Core XY machine; configuration
proved different. Currently using Cartesian configuration files.
What configuration files should I be using???

My initial pursuit was a Ballscrew Core XY machine; configuration
proved different. Currently using Cartesian configuration files.
What configuration files should I be using???

@phaedrux
https://share.icloud.com/photos/0KhsV-vT1zNMIi8HbYeDvEJZg
Before reading the above documentation I made it to this point.
Thanks for putting me back on track!!!

@droftarts
https://share.icloud.com/photos/0KhsV-vT1zNMIi8HbYeDvEJZg
That's 100mm/s!!!
Didn't understand Expansion Board page in RRF Config. tool. HELP PLEASE!!!

@o_lampe
https://share.icloud.com/photos/0KhsV-vT1zNMIi8HbYeDvEJZg
That's 100mm/s!!!
Didn't understand Expansion Board page in RRF Config. tool. HELP PLEASE!!!

I need help setting up my Duex 5 board w/ Duet WiFi; pictured is the build. Unsuccessful w/RRF Config. tool
on Expansion board page. The link below is the ambitious project.
https://a360.co/3av4BEB
Ballscrews utilized for movement; marginal success with Cartesian
setup in RRF tool. Homing, movement, speeds...etc
Where do I begin???

@phaedrux
Hey Phaedrux, re-flash worked; got an IP address/DWC. I'm learning. Til next time,

     **THANKS!!!**

@paulhew
Hey Paul, thanks for responding. The move backwards was a start from the beginning attempt. Could've made a better decision!!! First of all, I'm currently using a Mac Book Pro (not very familiar) and I'm not very computer savvy. Couldn't get BOSSA to work with Big Sur (Mac); gonna try Windows. Do I simply copy/paste v3 RC into browser
and (write)???

I've lost connectivity with DWC after reverting from 3.2.2 back to 2.05: can't get IP address with M587 command in Serial Tool. Where did I go Wrong? Wifi module (blue) LED lit. TNC400 2.4Ghz Network.

@phaedrux

Thanks. I'm on it!!! Question: What bearing will non-upgrade of config.g
after 2.05 to 3.0 RRF have. Can those file changes be done in 3.2.2 RRF?

@phaedrux
Not triggered
Triggered

Seems I have a wiring issue, Huh?
No movement w/G1 H1 X200 F600 in the Console.
Everything seems to work fine from dashboard, except
endstop and Error message below.
Warning: motor phase A may be disconnected reported by driver(s) 0 1
Warning: motor phase B may be disconnected reported by driver(s) 1
I'll revisit (X-drive) termination @board. Error follows termination point.