Topics created by Scachi

@Scachi said in Adding duex5 and all motor stop working:

I have removed the chip again,

You photo looks OK as far as I can see, however I suggest you check carefully for tiny solder bridges between the pads for the removed chip. A likely reason for no chips working (including drivers on the main board) is a short between one of the SPI MISO, MOSI or SCK pads and another pad.

Thank you for your answers. I will ground the frame plus the negative psu output like dc42 said.

@dc42 said in PanelDue 5" 1.22.1 beep startup tune playback problem:

The M400 command isn't needed

Good to know. It's a hold over from when I was originally trying to get it to work.

@dc42 said in PanelDue: two tools same heater, one pair of temp buttons:

I already have work scheduled to fix this.

Thank you very much for the fast response 👍

@dc42 David, so after many months of trying to get first a Laser and now a Magnetic sensor working.. I FINALLY HAVE IT WORKING! YAY. The sensor I got had a cracked piece of plastic not letting it tension the filament. The Installation guide should ensure there is tension on the filament before proceeding.

But to the reason i am posting here. Did the "post Script" ability every get implemented ? Like a Prusa I would like to allow it to do a specific action upon detection.

Thanks

The first step, moving the duet wifi from the cartesian style to the new core-xy style one did work fine without bigger issues.
The wiki about the corexy configuration and bltouch did help a lot 👍

A broken wire (white one, probe) in my bltouch and a bad crimped contact on the y-connected cable to the stepper-motor were the biggest issues.