Topics created by Keith53

@Keith53 said in Adding A Third Temperature Sensor:

Wonder why E3D calls it a PT1000?

If you ordered a PT1000, maybe they shipped you the wrong part?

@Keith53 said in Adding A Third Temperature Sensor:

Is there a way to get it to show up with Tool 0 and Bed so I do not need to push the "Extra" button to see the temp?

At present, only by creating a dummy heater that uses sensor 2 and a dummy tool that uses the dummy heater.

@Keith53 said in How to Set Z home:

Not sure why G92 Z-.03 did not work.

I'd have to see the actual file to venture a guess.

Using G92 in the homing files is a bit of a kludge honestly. Best to refrain if possible.

I believe you can specify the fan number in Cura in the printer settings.

@Phaedrux said in Duet 2 Ethernet Setup Warning.:

Is your Z connected correctly? The X and Y homing files probably have a Z move to lift the head out of the way for travel. If the Z axis isn't connected correctly you could get those warnings.

You were right Z moves up and then back down when X and Y are home individually. The warning does not happen now Thanks!

@dc42 said in Duet 2 Ethernet Setup Warning.:

@Keith53 said in Duet 2 Ethernet Setup Warning.:

Both winding were 4.5 ohms.

That's quite high, so you probably need 24V power to get good results from those motors. Are you using 24V?

Reducing the homing speed will probably get rid of the warnings.

What are the numbers on the motors?

If you can't find any data for those motors, then you can estimate the motor parameters by searching for motors of similar size (Nema 17?) and length with similar phase resistance.

I was wondering about getting a 24V PS. the numbers on XY and Z motors are
A4001-83HTS24LS
20161222238

Motor are 42mm square and 37mm long