Topics created by jtroutt19

Sorry I am late to the party- I was on the fence too, but after going through a couple of rounds with the connfigurator, it all worked itself out.

I had a devil of time upgrading becasue I lacked the prior experience of upgraging Duet FW. i was using RRF2 for LPC and bought a used Duet2 that did not come with the SD card.

But despite the potholes on the way, I think it was worthit for me.

@jtroutt19 said in Fan settings not working:

Is there any way to remap fan_2 and make it fan_0?

There are two ways. You can use RepRapFirmware 3 which allows you to map any fan number to any suitable output pin. Or you can use the F parameter in the M563 commands that you use to create tools, to specify which fan is the default print cooling fan for each tool.

@jtroutt19 said in Suddenly Started printing higher than usual:

Not sure how to even start answering that question.

Start printing. You'll know. One will likely be enough. I'm going to guess that the blowers from amazon are probably a little loud and pretty powerful. And they probably sent two because there's a good chance one will be DOA. So at least you have a spare.

@phaedrux

Yip I have experience that. Printed a couple cubes to see what different settings would do.

So changed jerk on the Z axis. Also upped accelerations a bit. The seem is starting to look good. I think I will be satisfied with this and move on to a bench test model and see how it performs and tune some more based on a for difficult print.
0_1554693687223_IMG_2454.jpg
0_1554693692893_IMG_2455.jpg

I got a picture of the issue with brim. The nozzle slows down while printing the brim in this one corner. Once it is done with the brim it no longer slows down in that corner. 0_1554693678511_IMG_2453.jpg

@Phaedrux

Ok I see it now. Right on thanks again