Got the sensor working but I'm getting a lot of reporting too little movement errors. The sensor is located immediately above a Titan Aero extruder so theres maybe 25 mm of filament between the sensor and the extruder drive. All is contained in ptfe tubing.
My current M591 output is:
M591 D0
Duet3D magnetic filament monitor on input 3, enabled, sensitivity 25.14mm/rev, allow 90% to 110%, check every 15.0mm, version 3, mag 131 agc 92, measured sensitivity 25.67mm/rev, min 91% max 104% over 45.1mm
I'm confused on why it paused at 91% when my threshold is set for 90%?
Regardless, I'm still getting instances where the percentage is down to 20% or so but no issues in filament movement.
Any suggestions would be greatly appreciated!