Topics created by Hytek

Well....this is gonna hurt. I did it! It was my fault. When I disassembled the module from the back of the display I realized I had forgotten to fit the 3v jumper. After installing the jumper I left the printer on for the day, ran a couple of prints and no issues. Considering the purpose of the jumper I guess I should consider myself lucky, didn't fry the screen.

Anyway, figured accept responsibility for my error and post it so I may save someone else the issues 🙂

@oliof Yeah I figured that was going to be the best answer. Thanks for the reply

Got idea maker working, replaced the 2 suspect lines with a single G28

Now Extruder works in reverse & I get a G221 no tool selected on job start up. Hopefully after I get those sorted will be happy times.

I ended up using Firefox. I set the web interface as my home page and that's all I use Firefox for. Seems wasteful but....

this might be suitable starting point for "conversion therapy" ?https://duet3d.dozuki.com/#Section_If_you_are_not_familiar_with_Duet_electronics_or_RepRapFirmware

No worries, you'll find there is a lot of right persons here, some of them are even right now 🙂

@Hytek you are welcome. Also with TCs the red wire is the negative in type K. The yellow is positive. I’m glad an old school trick was helpful.