Topics created by gbartsch

@Phaedrux said in Z Maximum and Z Position and Homing:

Nothing wrong with that.

😊

Just a follow up; since the upgrade I've printed steadily and have yet to experience a disconnect from DWC. That appears to be fixed (crossing my fingers).

@droftarts said in Can't run pressure advance g-code:

Check you are using Gcode with D0 rather than D3.

Thanks. I have been using D0 after @tas clarified that.

At this point I've changed so many variables and settings, and used different slicers, etc., that I don't know what wasn't working, BUT now that code runs through the slicer and is working.

I ran a coarse test and then narrowed the range down for a second test with finer ranges and now have a pressure advance value that's working well with PET-G. I'll run the test again with PLA and I'm really eager to see how all my machine's new settings with work with Ninjaflex. I really can't believe how much pressure advance is helping already.

I have a direct drive extruder (homemade with 78mm from the center of the drive gear to the nozzle tip) but seem to require quite a high pressure advance of S0.650 (2.85mm PET-G). Here's a picture (sorry for the poor quality).

pa.jpeg

Even though I don't know why it wasn't working, it is now, so I can say the issue is solved. Thanks a lot to everyone who helped with this!

@gbartsch To be clear, M109 will wait until the heater reaches temperature. My suggestion was to add an additional G4 pause after the M109 command. The length of the pause would equal the time it takes for the overshoot to settle. But DCs suggestion to reduce the overshoot would be better.

@Norder Oh thank you! This is very good and even easier than picking a scrollbar (if one existed). Because normally I click a scrollbar before using arrow keys I didn't even think to try this because said scrollbar didn't exist. Your suggestion is quite perfect - thank you again. 😃

@t3p3tony I'm getting one e-mail now. All is good. Best regards.

Thank you everyone for the comments. I'll need to digest everything and get it into my head. Take care.

@Phaedrux Thank you!