Extrusion Factors Buttons and Percentages
-
When I click the - or + button in Extrusion Factors in the DWC the jump is 5% either way. This is too large usually. Is there a place I can I set the amount the buttons increase or decrease the extrusion rate? Thank you.
-
Right click on the button, many of the jogging buttons allow you to choose the amount.
What version of DWC are you using?
-
Thank you for helping. I am using Duet Web Control 2.1.7. Right-clicking doesn't bring up options other than these. I would have thought this would be configurable the same as Babystepping.
-
For the slider you can drag it to set your exact value. It should only take effect when you release.
though I have to admit that I prefer the PanelDue button options for changing speed and extrusion factor.
-
I requested the same thing in the past, but it hasn't been implemented as of yet.
I think it would be very helpful to be able to choose the increment amount.
I use a 7" tablet attached to my printer, and dragging and releasing the slider to the exact percentage I want is damn near impossible. Tapping a butting for a 1% change would be much more reliable.
-
@Phaedrux Thank you. Because I have a disability I am not good at precisely dragging the slider; I do it - but it would be MUCH easier clicking the button.
-
@CCS86 Do the devs see posts such as this or maybe I should also request the feature?
-
I've moved to the DWC wishlist for @chrishamm to see.
-
@Phaedrux Thank you!
