Topics created by gabi68

@gabi68 alright, I missed that you have a delta. I am assuming you need to run G32 before every print unless you fix the delta values to be correct (consider autocalibration).

@gabi68 said in Berd-air pump connection:

Firmware Version: 2.03 (2019-06-13b2)
WiFi Server Version: 1.23
Web Interface Version: 1.22.6

If you still have access to DWC. Upload these 3 zip files, one at a time in the system tab. Don't extract them first. Reboot after each. Use M115 in the gcode console to verify the firmware has been applied.
https://github.com/Duet3D/RepRapFirmware/releases/download/2.05.1/Duet2Firmware-2.05.1.zip
https://github.com/Duet3D/RepRapFirmware/releases/download/3.0/Duet2and3Firmware-3.0.zip
https://github.com/Duet3D/RepRapFirmware/releases/download/3.3/Duet2and3Firmware-3.3.zip
That will get your firmware and DWC up to date.

You can see the change logs here:
https://github.com/Duet3D/RepRapFirmware/wiki/Changelog-RRF-3.x

For your config, might be a good idea to run through the configurator tool and generate a fresh set for RRF3.
https://configtool.reprapfirmware.org/Start

Backup your existing config files in the sys folder in case you want to switch back to RRF2. It’s easy to switch back and forth, just upload the zip file for the version you want and then upload your config files.

These documents will come in handy during the conversion.
https://duet3d.dozuki.com/Wiki/RepRapFirmware_3_overview
https://duet3d.dozuki.com/Wiki/Gcode

Hi,

Can you use a PT1000 ?
uses the standard thermistor socket but much higher temp rating 450cish I believe.

Are you sure that you haven't inadvertently configured your slicer to change the temperature or some other parameter at layer 16?

Or perhaps the nature of your model changes a lot at layer 16, e.g. changes from having large infill areas to small infill areas?

@gabi68 said in Heater 1 fault:

@dc42 Red

Looks like E3D PT100 is red https://e3d-online.com/pt100-temperature-sensor
Thermocouples usually have a braided cover https://e3d-online.com/type-k-thermocouple-cartridge
Thermistors are blue https://e3d-online.com/thermistor-cartridge

So probably still just a failed PT100.

Ian

@bricor I just measured. The multimeter stays 0. Agree I will close this.

Thanks for your help
Gabi

@deckingman
Thank you

Sadly there is no standard for what connectors are used on 3D printer electronics. We don't use the 2.54mm Dupont connectors that are used on RAMPS and some other board, because they don't lock in place (so they can fall off) and they are not polarised (so it's too easy to connect them the wrong way round). The JST ZH connectors used on some Chinese boards are harder to crimp then the Molex KK style connectors that we use on Duets.

If your Anycubic Kossel uses 2.54mm Dupont connectors, then the stepper motor, fan and thermistor connectors may fix the Duet already (but be sure to connect the fans the right way round). The endstop connectors will need to be changed.