Your browser does not seem to support JavaScript. As a result, your viewing experience will be diminished, and you have been placed in read-only mode.
Please download a browser that supports JavaScript, or enable it if it's disabled (i.e. NoScript).
undefined
@fishpig said in Filament not extruding:
I have loaded all the macros included in the firmware installation
From where did you get them?
@fishpig said in Skipping grid point:
G29 X400 Y400
That's not a valid command.
See here for using mesh compensation: https://duet3d.dozuki.com/Wiki/Using_mesh_bed_compensation
@Phaedrux I ordered a board and expect it to arrive by October. If I don't manage to find the offending change by a couple bisecting builds, I'm happy to send it over to Duet3D for inspection.
