Topics created by davidvh86

@davidvh86 you can read more about it here:

https://forum.duet3d.com/topic/18485/oozebot-ele-gant

Thanks

@davidvh86 said in Creating thermostatic fan without heater:

yes i am. so would i replace h# with s3

The parameter in M106 is still H but its value in RRF3 is a sensor number, not a heater number.

No problem. Glad I could help.

The gcode wiki is a great resource. You should always have it open in a tab. Any time you're wondering if you can do something or how something works, searching the wiki there can be a big help.

https://duet3d.dozuki.com/Wiki/Gcode

Since everything is configured with gcode, and there is basically a gcode for everything, and anything can be configured on the fly, anything you can think of doing, you can probably do.

Worked thanks guys

Ok ill try it out tonight, Thanks.

I don't know if this means that the M557 must be the entire size of the bed and therefore provoke the skipped points for it to get entered into the heightmap as 0 and cause it to extrapolate, or if it will automatically extrapolate any bed area outside of the M557 defined area.

@Phaedrux
lmao, thanks for the help this project is never ending, It went from a planned 2 week conversion to 4 months lol.

@davidvh86 I just had to do the same. I thought I was being stupid for a good bit before I worked out it wasn't me.

I used to have my home call in my config.g but I was advised to not do that. So I have removed it. I just put the G30 and G29 in my starting script for my slicer. I also usually home at the start of my print files.

I was able to write a macro to actually use the stall detection to automatically calculate the probe trigger height. So I may change how I do a few things now too. But I literally figured that out last night so I haven’t really had a chance to figure out how I’ll implement it.

@davidvh86 said in Control 5 volt relay:

@dc42 Thanks for the reply, how would i designate that pin as the output in the configuration files. Like i said earlier im used to smoothieware where i have one config file where i specify the pin output and whether its pwm or not.

For maximum flexibility in allocating pins, I suggest you use RepRapFirmware 3.01. This is close to release now and the release candidate is stable.

You can use the online configuration tool to specify which pins you want to use. It will generate M950 commands in the config.g file to assign those pins. See https://duet3d.dozuki.com/Wiki/Gcode?revisionid=HEAD#Section_M950_Create_heater_fan_or_GPIO_servo_pin.