Topics created by Computiger

I´ve just tried two other servo´s, these ones run fine like accepted.
They are much cheaper than the 1st one. I have to check the wire.

Thanks

A three position connector similar to the other Duet connector (Molex KK) should fit well on that fan selection header.

sounds good, thanks

I´ve tried that but w/o any success
After rebooting I´ve tried again and it seems to work. No Idea why it didn´t work before, hmm

I found M119 to get the sensor status

Thanks David,

that was the reason. 🙂

I've had Web Control 2.0.0RC2 installed for a while and not had this problem until 2 days ago when firefox had an update. The problem isn't there if I open the interface in Microsoft Edge but obviously Edge is crap because it doesnt allow streaming from the camera.

@computiger said in Motor movement issue:

I found my problem. My motors are ok.
After I renewed my mesh bed level settings, motors could run more than 300mm/s w/o any stutter.

Enabling mesh bed compensation can cause moves longer than the mesh spacing to slow down at the segment boundaries if the Z jerk is set too low.